Assigning direct out to 2 x card slots
2 posters
PM5D.org :: PM5D :: General PM5D
Page 1 of 1
Assigning direct out to 2 x card slots
Hi
I was using a Avoim output card with a PM5D-RH and had it in slot 3. In slot 2 was an Analogue 8ch output card. I had channel 1 routed to Slot 2-1. I also had it assigned to Slot 3-1. Only audio out slot 2. Selected the channel showed direct output was slot 2-1. Is it possible to assign to both slot 2 and 3 at the same time?
cheers
I was using a Avoim output card with a PM5D-RH and had it in slot 3. In slot 2 was an Analogue 8ch output card. I had channel 1 routed to Slot 2-1. I also had it assigned to Slot 3-1. Only audio out slot 2. Selected the channel showed direct output was slot 2-1. Is it possible to assign to both slot 2 and 3 at the same time?
cheers
nickpnz- Posts : 4
Join date : 2008-05-17
Re: Assigning direct out to 2 x card slots
As far as I know, you should be able to route a single channel to more than one output, you just can't route more than one channel to a single output. However, the manual doesn't say anything about allowing this for direct outs.
bubba_b- Posts : 3
Join date : 2009-04-23
PM5D.org :: PM5D :: General PM5D
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|